Olympia Chimney Flue Liner Replacement Nationwide

Olympia Chimney Flue Liner Replacement: The Alpharetta Owner’s Guide

We stock and install Olympia Chimney-compatible flue liner replacements for Alpharetta homes, with most jobs running between $1,850 and $3,400 installed depending on liner length, diameter, and whether we’re working through an existing chase or opening the wall. Most homeowners discover the liner has failed during a routine sweep, when we spot flaking metal, rust-through, or loose seams on camera. What starts as a slightly smoky fireplace or a faint metallic smell near the chase usually turns out to be a liner that’s quietly been degrading for several Georgia heating seasons. The good news: we carry Olympia Chimney-series flexible liners and rigid sections on the truck, so most Alpharetta replacements are done in a single visit.

Call (762) 225-2593

The thing about Olympia Chimney liners is they’re built to a 304 or 316 stainless spec depending on the series, and they fail at the seams and the flat-lock crimps before they fail anywhere else. In Alpharetta, where we get humid summers that pull moisture into the flue and then cold snaps that freeze that moisture against the liner wall, we see corrosion start at the joints faster than homeowners expect. A liner that looks fine from the top can be paper-thin three feet down. If you’re noticing a brittle smell when the fireplace runs, or you see rust stains on the chase exterior, don’t wait for the next burn season, call (762) 225-2593 and we’ll put a camera up there and show you exactly what’s happening.

Which Olympia Chimney Models This Applies To

Olympia Chimney makes liner systems under a few series names that show up regularly in Alpharetta: the Flexi-Liner and the Dura-Vent-compatible Olympia Pro series are the two we see most often in wood-burning and gas-converted fireplaces from the 1990s through the 2010s. The model label is usually on the interior of the appliance door frame or on the firebox floor, and it’ll read something like “Olympia Chimney, Model OL-6” followed by a diameter and gauge number. If the label is faded or gone, we measure the existing liner inside the flue, but here’s the gotcha: Olympia Chimney’s 6-inch liners are true 6-inch ID, and some aftermarket equivalents are 5.5-inch ID with thicker wall. That half inch matters for draft and for matching the existing termination cap, so we verify against the original specification before quoting the job.

We install genuine Olympia Chimney liners when the home already has an Olympia system, and we also carry DuraFlex and Gelco equivalents where an aftermarket option makes sense for the homeowner’s budget. The honest split is this: a genuine Olympia Chimney replacement makes sense if you’re keeping the fireplace long-term and the chase is in good shape. An aftermarket 316L liner from DuraFlex will often cost $250 to $400 less and perform identically for Alpharetta’s burn seasons, but it won’t match Olympia’s original termination cap threading exactly, which means a small adapter may be needed. We’ll walk you through that decision on the phone before we ever book the visit, and you’ll get a written price either way.

Signs Your Olympia Chimney Flue Liner Replacement Is Failing

Here’s what we see, walking through Alpharetta homes with Olympia Chimney systems that need a new liner. If you’re seeing any of these, we should look:

• Rust flakes on the smoke shelf or firebox floor. This is the most common sign. The liner is shedding from the inside out, and those flakes are the inner wall of the flue landing where you can see them. By the time you see rust, the liner has likely been compromised for at least one full season.
• A metallic or chemical smell when the fireplace heats up. Heating a failing stainless liner releases an acrid smell that people describe as a burning metal or a chemical sharpness. That smell means the liner is oxidizing under heat, and it won’t go away on its own.
• Smoke spilling into the room during start-up or in windy conditions. Cracks and seam failures change the draft characteristics of the flue. Your chimney goes from pulling air to pushing air unpredictably, and the first thing you’ll notice is a puff of smoke when the fire catches.
• Visible gaps or dark staining at the liner seams during a flashlight check from the top or through the cleanout. If you can see a seam opening, even a hairline gap, that flue is no longer a closed system. Carbon monoxide and creosote vapor can exit through that seam into the chase cavity.
• Water staining on the ceiling near the chimney chase after heavy rain. A failing liner is often the starting point for moisture intrusion. Rain enters through the deteriorating cap or top plate, and once it’s past the flashing, the liner is the next thing it touches on the way down.

None of these signs mean panic, but they all mean the same thing: the liner is past its useful life and should be replaced before the next burn season. We’re happy to confirm any of these with a camera inspection, and we’ll show you the footage before we recommend anything.

Replacement Cost & What’s Included

For Alpharetta homes with a standard single-story chase and an Olympia Chimney liner, a complete replacement typically runs between $1,850 and $2,600 installed for a 6-inch flex liner up to 25 feet. Two-story homes with longer liners, or jobs that require a new top plate, rain cap, or chase work, usually land between $2,400 and $3,400. The range depends on three things: the liner length and diameter, whether we’re replacing the termination cap and flashing at the same time, and whether the chase top needs sealing. Every quote includes the liner, all connectors and adapters, the top plate and rain cap if needed, labor, and the Cedarwell Care Promise, which means drop cloths down, nothing moved without asking, a written price before the first tool comes out, and a photo of the clean-up before the crew packs up.

We don’t do open-ended pricing on liner work. The number you approve is the number you pay, unless we find something genuinely unsafe that changes the scope, and in that case we stop and call you with photos before touching anything else. Every Olympia Chimney flue liner replacement we do is covered by the 365-Day Done Right Promise: if the liner doesn’t draft correctly or anything about the install isn’t right, we fix it. Danny Cortes has been doing this long enough to know that a liner that drafts poorly is worse than no liner at all, so we test the draft before we call the job finished.

Here’s the Alpharetta price picture in plain numbers:

• 6-inch Olympia Chimney-compatible flex liner, up to 25 ft: $1,850 – $2,600 installed
• 6-inch liner with new top plate and rain cap: $2,300 – $2,900 installed
• Two-story or extended-run liner (26 – 40 ft): $2,600 – $3,400 installed
• Camera inspection only, no liner work: $189, applied in full to any liner replacement we do within 60 days

We carry genuine Olympia Chimney sections and DuraFlex equivalents on the truck when we come to Alpharetta, so we’re not sending you a quote, waiting on a part, and then asking you to reschedule. Most liner replacements are done the same day we open the chase.

DIY or Call Us?

You can absolutely check a few things from the ground: look for rust flakes in the firebox, shine a flashlight up from the smoke shelf to catch obvious seam gaps, and note any smell when the fireplace runs. Those observations help us understand what’s happening before we even arrive. What you shouldn’t do is try to pull or replace a liner yourself. A flue liner lives inside a vertical chase that’s often 20 to 35 feet tall, and working at height on a roof in Alpharetta, with the slope and the Georgia heat, is where this goes from a bad idea to a genuinely dangerous one. The liner also has to be sized, connected, and pulled under tension, and a liner kinked during installation will draft poorly and strand you with a fireplace you can’t safely use. That’s a job for a crew with the right rigging and the right insurance.

We also don’t recommend the homeowner act as their own inspector when monoxide is in play. A liner that’s compromised at the seams can be moving carbon monoxide into the chase cavity and then into the house through a tiny gap in the framing. If you’re seeing rust or smelling metal, let us put the camera up and tell you plainly whether the liner is done or can wait. The call is easy: (762) 225-2593. A real person answers, and you’ll get a straight answer, not a sales pitch.

FAQs